Inner Airlock beadlocks are a true double beadlock that features an ultra-strong case that goes inside your tire. Inside that case is an inner-tube. Once you inflate the inner-tube in locks both the inside and ouside tire beads against the wheel. This creates a run-flat like style system with little to no slipping on any of the parts. They are available from a 15x7 inch wheel all the way to a 20x14 in wheel. Custom orders can be build upon request.
|15"||YES||YES||YES||YES||YES (ADD $10)||YES (ADD $10)|
|16"||YES||YES||YES||YES||YES (ADD $10)||YES (ADD $10)|
|16.5"||YES||YES||YES||YES||YES (ADD $10)||YES (ADD $10)|
|17"||YES||YES||YES||YES||YES (ADD $10)||YES (ADD $10)|
|20"||NO||NO||YES (ADD $45)||YES (ADD $45)||NO||YES (ADD $55)|
RECOMMENDATIONS & CAUTIONS
**For Off-road use lower the tire to your desired pressure...with a minimum of 5 psi please**
**Always maintain the InnerAirLock at 30 psi**
**NEVER inflate the InnerAirLock InnerTube above 40 psi**
**InnerAirLock Cannot beheld liable for our Units being INCORRECTLY Installed And/Or Used in a manner for which they were NOT INTENDED.**
Note: If you are outside the Continental U.S. the shipping costs may vary. The estimate is just that,
the ACTUAL cost may be higher or lower depending on location and quantity purchased.
Inner Air Lock Installation (Simplified) Installing a set of Inner Air Lock beadlocks is a simple process as long as you take you time and follow the provided instructions carefully.
|Step 1 File down any sharp edges on your wheels and then sand them down and clean them to remove any dirt.||Step 2 Drill a hole to accept the secondary valve stem that will be used to inflate the inner beadlock tube.||Step 3 Lube the inner bead of the tire and install it on the wheel.|
|Step 4 Apply a generous amount of talc powder to the Inner Air Lock and the inner tube.||Step 5 First install the inner bead of the Inner Air Lock and then insert the inner tube.||
Step 6 Carefully install the outer tire bead and follow the detailed inflation instructions.